Parts & Online Orders

Call 800-229-6690

Bleeding Trailer Brakes - FAQ

BLEEDING THE BRAKES

You have now completed the hardware installation and are ready to bleed the brakes.

First fill the brake coupler master cylinder reservoir with DOT type 3 brake fluid (not provided with kit).

Next go to the brake cluster wheel cylinder farthest from the master cylinder in the tubing sequence.

Open the barbed bleed valve on that wheel cylinder one turn, with a 3/8" open end wrench. Obtain a piece of 5/16" plastic hose about two feet long, push the piece of hose onto the bleed valve barb. Now you will need a clear container (BRAKE FLUID IS TOXIC. DISPOSE OF PROPERLY.) to use as your fluid receiving container. Set the fluid receiving container on top of the trailer fender or at some point above the wheel cylinder.

Now route the plastic hose from the bleed valve barb to the fluid receiving container. NOTE: The fluid receiving container must be above the wheel cylinder so that any bubbles trapped in the bleed hose will flow up away from the wheel cylinder, not back towards it, which would be the case if the fluid receiving container were lower than the wheel cylinder.

Going back to the brake coupler, insert a large screw driver into the 1/2" dia hole in the coupler under the nut on the pushrod which extends out the front of the brake coupler housing. With your screw driver in place in this hole, you can use a back and forth motion to apply levered pressure directly to the master cylinder pushrod, by passing the coupler and shock damper mechanism.

Remove the cap on the master cylinder reservoir and using small 1/2" forward and backward strokes on the screw driver, you will begin purging air from the piston portion of the master cylinder assembly. Bubbles will rise from a small hole in the bottom of the reservoir. As you continue with the 1/2" back and forth motion, bubbles will continue to rise until the piston portion of the cylinder is full of brake fluid. Only when you have No more bubbles rising in the master cylinder reservoir should you begin long strokes on the screw driver to pump fluid toward the wheel cylinders. NOTE: Once you have the piston portion of the master cylinder full of brake fluid and no more bubbles are rising in the reservoir, USE CAUTION. Do not look directly down into the reservoir while pumping the push rod. The brake fluid will squirt up with considerable force during the first part of each pump stroke. Don't let it hit you in the face. Set the filler cap on top to control this squirt.

Now as you pump brake fluid into the system, you will begin to see it arrive at the fluid receiving container. (CAUTION - Never let the reservoir fall below 1/2 full during the bleeding process) If the fluid gets too low and sucks air down into the piston of the master cylinder, you must start over and the new air just sucked in and all brake fluid already in the system will need to be purged out. As you pump fluid thru the system, the bubbles you have been seeing in the fluid receiving container will cease. This indicates that you have completely filled the system with brake fluid.

Now, with the bleed hose still on the bleed valve barb, close and tighten the bleed valve. Remove the hose and go to the wheel cylinder on the other side of the trailer and repeat the process. After completion of the bleeding process, refill the master cylinder reservoir and reinstall the reservoir fill cap and tighten.

Next, apply pressure to the push rod and hold hard pressure on the screw driver for five or ten seconds. This will develop maximum hydraulic pressure on the system, and make it easy for you to see fluid if you have any leaks. After totally checking the system for leaks, you are now ready to adjust the brakes.

Replacement trailer parts for your boat or utility trailer.  We offer a variety of trailer parts such as axles, springs, hubs, lights, jacks, and more!  Don't forget our custom built galvanized boat trailer axles for an exact fit to your trailer.  

**All images, articles, catalogs, and descriptions on our site and catalog are subject to copyrights and trademarks.  Use of these items without prior written approval will be considered to be infringing on our trademarks and copyrights and will be dealt with accordingly.